UNIT 1:
Introduction to the design process - factors influencing machine design
Introduction to the design process - factors influencing machine design
Direct, Bending and torsional stress Equations
Calculation of principle stresses for various load combinations
Design based on strength and stiffness Factor of safety, theories of failure
UNIT 2:
Soderberg, Goodman and Gerber relations.
UNIT 3:
Design of solid hollow shafts based on strength
Design of Rigid couplings
Design of Flexible couplings
Design of Rigid couplings
UNIT 4:
Design of helical springs under constant and variable loads.
Design of helical springs under constant and variable loads.
Design of leaf springs under constant and variable loads
Design of leaf springs under constant and variable loads
Design of torsional springs under constant and variable loads
Design of torsional springs under constant and variable loads
Design of Rolling Contact Bearing
Design of Sliding Contact Bearing
Design of Sliding Contact Bearing
Design of Sliding Contact Bearing
UNIT 5:
Design of Welded Joints (CBS)