Introduction to Design - Study of loads-moments and stresses on frame members - Design of Vehicle frame -Analysis of loads-moments and stresses in front axle - Design of front axle beam – Wheel Spindle Bearing.

Condition for True Rolling – Ackermann Principle in Steering System – Design of Steering System Components - Design of leaf Springs-Design of Coil springs – Design of torsion bar springs

Design of Cylinder – Design of Piston, Piston pins and Piston rings – Design of Connecting rod – Design of Valves - Design of Exhaust and Intake Manifold – Design of Crankshaft

Design of single plate clutch - Design of multiplate clutch - Design of Centrifugal clutch – Layout of Gearboxes - Design of three speeds and four speed gearboxes

Design of Propeller Shaft – Design of Rear Axle Drive Assembly - Energy Absorbed by brakes –Heat to be dissipated during braking – Design of Drum Brake – Design of Disc Brake